We thank you for choosing Focal amplifiers for your Car Audio system and for sharing our philosophy: “the Spirit of Sound”. This product offers the la
WARNINGThe cable that links the positive (+) terminal to the battery at the amplifier’s “+ BATT” binding post terminal must ABSOLUTELY be fused (see c
- Insert the new fuses in the fuse holder. Make sure that the new fuse rating corresponds to the product specifications. - Put the
3.12 - Focal amplifiers can be interlinked to facilitate upgrades to the Car Audio system. If you want to create a system that uses several amplifiers
installation
Focal Power 2.150 and Focal Power 2.75Focal Power 4.75the amplifiers14notice amplis focal power gb.ind14 14notice amplis focal power gb.ind14 14 2
Ajouter Ajouter LEGENDSConnections, features and controls INPUT(S): the RCA sockets are used for input of the line level signal.NOTE: the RCA inputs
LEGENDS LO PASS (low pass): the LO PASS potentiometer means that you can set the low pass filter frequency.The value selected is the freq
LEGENDSConnections and functions specific to the FP 1.800 amplifier REMOTE CONTROL: NOTE: DO NOT CONFUSE REMOTE AND REMOTE CONTROL. The REMOTE CONTRO
In order to optimise the overlap of frequency ranges reproduced by the subwoofer and the coaxial or2-way kits, we advise you to
WARNING02• Do not turn on any function which may distract you while driving the vehicle. Functions requiring sustained attention must only be used wh
Technical specificationsFP 2.75 FP 2.150 FP 4.75 FP 5.500 FP 1.800Nominal RMS power measured at 13.8V continuously @ 4Ω2x75W 2x150W 4x75W4x75W+1x200W1
troubleshooting1 The LED indicators on the top and on the side of the amplifier are off:- Check that there is a DC voltage of 10.5 to 15.5V at the amp
troubleshootingOnce all these verifications have been undertaken and if the amplifier still does not work, contact your nearest Focal distributor.8 No
SETtingSGainX-over 1-2X-over 3-4Hi-passLo-passSubsonicBass boost levelBass boost frequencyPhaseGainX-over 1-2X-over 3-4Hi-passLo-passSubsonicBass boos
SETtingSGainX-over 1-2X-over 3-4Hi-passLo-passSubsonicBass boost levelBass boost frequencyPhaseGainX-over 1-2X-over 3-4Hi-passLo-passSubsonicBass boos
Nous vous remercions d’avoir choisi Focal pour l’amplification de votre système Car Audio et de partager avec nous notre philosophie
avertissement• N’activer aucune fonction susceptible de détourner votre attention lors de la conduite du véhicule. Les fonctions requérant
L’écoute prolongée à fort niveau, au-delà de 110 dB, peut détériorer durablement l’audition. Des écoutes, même brèves, au-delà de 130 dB, peuvent prov
Matériel requis pour effectuer l’installation :• 2 gaines de section adéquates (1 gaine pour le câble d’alimentation, 1 gaine pour le
La section ci-dessous traite de points relatifs au véhicule dont il faut tenir compte pour l’installation de l’amplificateur. Vous gag
Listening for prolonged period at a high volume level, over 100dB, can lead to permanent deterioration of your hearing. Listening at a v
I - Mise en place et câblageOù installer l’amplificateur ?En raison de la puissance de l’amplificateur, une forte chaleur est produite lors du fonctio
3 - CâblageAVERTISSEMENTEn cas de doute sur l’aptitude à installer l’amplificateur et câbler le système de façon adéquate, confier cette tâche à un re
3.2 - Faire cheminer ensemble les câbles de modulation (RCA), les câbles haut-parleurs, le câble REMOTE, ainsi que le câble REMOTE CONTROL {la REMOTE
3.5 - La phase de connexion des câbles de modulation (RCA), REMOTE et câbles haut-parleur peut débuter. Connecter les RCA à l’amplifica
ATTENTIONLe câble reliant la borne positive (+) de la batterie au bornier “+ BATT” de l’amplificateur doit IMPERATIVEMENT comporter un fusible (valeur
- Placer le nouveau fusible en s’assurant de la parfaite correspondance d’ampérage. - Mettre le capot en place puis visser les vis.- Tourner l’amplifi
3.12 - Les amplificateurs Focal peuvent être reliés entre eux afin de faciliter l’évolution du système Car Audio. Dans le cas d’une multi-amplificatio
installation
Focal Power 2.150 et Focal Power 2.75Focal Power 4.75les amplificateurs38notice amplis focal power fr.ind14 14notice amplis focal power fr.ind14 1
Material required for the installation:• 2 conduits of suitable cross-section (1 conduit for the power cable, 1 conduit for the loudspeaker, REMOTE, •
LégendesConnexions, fonctions et réglages INPUT(S) : les fiches RCA sont dédiées à l’entrée du signal bas niveau.NOTE : les entrées RCA des amplific
LégendesConnexions et fonctions spécifiques aux amplificateurs FP 1.800 et FP 5.500 LO PASS (passe-bas) : le potentiomètre rotatif LO PASS permet de
GAIN : le potentiomètre rotatif GAIN permet de rehausser le niveau du signal bas niveau entrant dans l’amplificateur à destination du subwoofer UNIQ
Afin d’optimiser le recoupement des fréquences retranscrites par le subwoofer et le kit coaxial ou deux voies séparées, nous conseillons de régler la
SpécificitésFP 2.75 FP 2.150 FP 4.75 FP 5.500 FP 1.800Puissance RMS nom. à 13,8 V continu sous 4 Ω2 x 75 W 2 x 150 W 4 x 75 W4 x 75 W +1 x 200 W1 x 40
dépannage1 Le témoin lumineux situé sur la face supérieure de l’amplificateur est éteint :- Vérifier la présence d’un courant continu de 10,5 à 15,5
dépannageUne fois toutes ces vérifications effectuées et si l’amplificateur ne fonctionne toujours pas, contacter le revendeur Focal le p
réglagesGainX-over 1-2X-over 3-4Hi-passLo-passSubsonicNiveau du bass boostFréquence du bass boostPhaseGainX-over 1-2X-over 3-4Hi-passLo-passSubsonicNi
48réglagesGainX-over 1-2X-over 3-4Hi-passLo-passSubsonicNiveau du bass boostFréquence du bass boostPhaseGainX-over 1-2X-over 3-4Hi-passLo-passSubsonic
Nous garantissons la confi dentialité de ces informations. Conseil du revendeur Conseil d’amis, relation Visite d’exposition, salon Article de pr
The below section deals with issues regarding the vehicle which are necessary to take into account for the installation of the amplifier. You’ll save
garantie amplis focal power.indd2 2garantie amplis focal power.indd2 2 28/09/06 16:14:3228/09/06 16:14:32
Cassette: CD: Navigation: Multimedia center: DVD: Loudspeakers: CD-change: Other elements:The information given on this page will remain confi den
Focal-JMlab® - BP 374 - 108, rue de l'Avenir - 42353 La Talaudière cedex - FranceTel. (+33) 04 77 43 57 00 - Fax (+33) 04 77 43 57 04 - SCOS-0512
I - Set-Up and CablingWhere to install the amplifier?The amplifier power is such that substantial heat is generated when it is operation. This is why
3 - CablingWARNINGIf there is a doubt as to your ability to install the amplifier and to cable the system properly, get a Focal distributor to do it f
3.2 - Route the low-level audio cables (RCA), the loudspeaker cables, the REMOTE cable, and the REMOTE CONTROL cable together (a REMOTE CONTROL is ONL
3.5 - You can now start the connection phase – i.e. connection of the audio signal (RCA), REMOTE, and loudspeaker cables. Connect the RCAs to the ampl
Kommentare zu diesen Handbüchern